SO I have inherited an older C7000 with G6 blades. ALl is working fine however I am trying to add an addition card in the back so I have new connections for the hosts to use.
Right now the cards in back are:
Inneterconnect 1 VC Flex-10 Enet
Interconnect 2 VC Flex-10 Enet
Interconnect 3 HP B series 8/12c
Now I have added a 1/10 VC Enet card to bay 5. It shows up in OA and everything is green. However none of the ports are mapped (thought this would happen automaticly) I was able to SSH in and assign it an IP address for management however it doesnt appear to be working since I can not access it and OA still says it managment IP is 0.0.0.0
So..am I doing something wrong or missing something? Not too familar with the HP C series so have been trying to figure out how to connect the new card to the existings blades.
Ken